9
on each side of the frame. Additionally, it’s fixed to the foot rest with
2 pushbuttons
(b)
. On each side of the seat, there’re 2 push buttons
(c)
where the wind protection of the hood are fixed.
• (Fig. IV)
Insert the hood into the holders
(4)
on the outer push bar
and into the holder on the centre push bar. Then it is secured to the
seat and the frame
(d)
with two push buttons
(c)
. It can be
additionally secured to the centre bar with a belt. If you open the
zipper
(5)
, you can extend the hood further forwards.
• (Fig. V)
For the assembly of the rear wheels, insert the axle
(6)
in the
frame so that the brake is also located in the holder. Mount the
brake calliper
(7)
in the M-brake
(8)
. If you want to remove the
wheels, release the brake cable
(7)
and press the kangaroo button in
the centre of the wheel. Now you can remove the wheels.
• (Fig. VI)
For the initial assembly of the front wheel, first push the
quick-release hub axle
(12)
through the fall-out protection piece
(“nose” facing the wheel) and then through the wheel hub. After
that, push on another fall-out protection piece (“nose” facing the
wheel) and secure the axle with the knurled nut
(14)
. Then insert the
wheel into the front fork
(15)
and tighten the knurled nut
(14)
slightly
with the quick-release lock
(12)
still open. Make sure that the “noses”
of the fall-out protection pieces are positioned in the provided
openings. You can now close the quick-release lock
(12)
so that the
wheel is positioned firmly in the front fork
(15).
Inside of the wheel
attachment you find two set screws
(13)
to adjust the straight running
when necessary.
• (Fig. VII)
B
ackrests can be continuously adjusted with the belt. To
this end, you must press both plastic parts
(13)
together and adjust
the seat angle with the belt.
• (Fig. VIII)
The foot rest can be folded upwards. To this end, it must
be locked in place with the foot board
(14)
.
• (Fig. IX)
Close the belt buckle by audibly engaging both plugs
(15)
in the belt buckle
(16)
. If you want to open the harness, simply press
the button in the centre of the buckle
(16)
. The harnesses can be
adjusted to the size of your child using the tensioning system x, y and
z. The harness is located at the 5 points x, y, z.
• (Fig. X)
Insert the belly bar from above into the frame tubes. Secure
it by moving the clamping lever
(17)
. By pressing the red buttons
(18)
at the left and right side you can swivel it to different positions.
• (Fig. XI)
You can set the height of the push bar by pressing the two
adjustment joints
(23)
.
• (Fig. XII)
The handbrake is a walking and parking brake at the
same time. To activate the parking brake, you must pull the brake
lever
(20)
fully tight and completely close the red parking lever
(21)
,
Summary of Contents for Joggster Sport
Page 56: ...56 TFK Joggster Sport 6 15 1 5 TFK 5...
Page 59: ...59 30 2 TFK UV TFK...
