2. Parking method
When parking, please pay attention to those vehicles and pedestrians around. D o not
park it on a slope. Operation method for electricity indication
3. Operation method for electricity indication
After the power supply lock is connected, the voltage indicator light will be turned on.
At full charge of capacity, there are green, yellow and red light, with 5 grids in total. The
green light has three grids, with each grid of 25% of rated electricity; each grid of the
yellow light is 20% of rated electricity; while each grid of the red light is 5% of rated
electricity. The yellow light going out while the red light going on indicates that there
is no electricity left, so when you find that the blue light goes out, you should charge
the scooter immediately.
4. Operation method for power supply lock
After the key of the power supply lock is turned by a shift in clockwise direction for
connection, the motor can be started up. During driving, you do not remove the key
and switch off power supply, nor can you turn the key in counterclockwise direction to
close the power supply lock. Once you switch oft the power supply, the motor will stop
running. After parking, you should turn the power supply lock in counterclockwise
direction to switch off the power supply, and then pull the key out.
5. Turning handle (speed-governing handle)
If the turning handle is turned towards the driver, the bicycle will be speeded up; and
if it is released to turn back, the speed will be reduced. After reset, cut off the power
supply of motor.
6. Operation method of disc brake and considerations
a) Operation method of disc brake
Brake clearance adjustment: turn the adjusting screw which is located
between the braking handle and the handlebar tube using a 2mm Allen
wrench, adjust the clearance between braking pads and the braking disc
until your hand feeling is comfortable.
Replace the braking pad when braking pads are worn off by more than
1mm or the adjusting screw of braking pads are adjusted to the end
position or every half a year. When replacing braking pads, press in one of
braking pads using a clean slotted screwdriver to vacate space for taking
out the other braking pad. After replacement is complete, it is needed to
return the adjusting screw of braking pads to a suitable position (a position
that makes your hand feeling comfortable).
Run-in period: the run-in of disc brake surface needs a certain time. After
complete run-in, braking force will increase significantly. The first week in
which you use a new disc brake is the run-in period. During run-in period,
do not brake with too great force, otherwise un-recoverable damage will be
caused to braking pads and braking body. The correct operation method is
to brake slightly during driving, so that there is appropriate friction kept
between braking pads and the disc brake.
Oil replacement: this disc brake adopts mineral oil, which should be
replaced (2-3 years in general) when the braking handle is felt weak.
Replace oil using an injector.
Summary of Contents for EBIKE
Page 1: ...THAMLEV EBIKE MANUAL...
