Owner’s Manual
Owner’s Manual
4
Attach the Front Stabilizer (No.
23) and the Rear Stabilizer (No.
10) to the main frame using:
4 – Carriage Bolt (No. 9)
4 – Arc Washers (No. 11)
4 – Domed Nuts (No. 12)
Place the Front Stabilizer (No.
23) against the main frame and
be sure the holes line up. Take
two of the Carriage Bolts (No. 9)
and pass them through the tube
supports located on the unit.
Slip the two Arc Washers (No. 11)
over the threaded portions of the
carriage bolts. Place the two
Domed Nuts (No. 12) over the
Arc Washers (No. 11) and firmly
tighten down the Domed Nuts
(No. 12) using the wrench
provided.
Notice: The Front Stabilizer (No. 23) has wheels for moving your Orbitrek Magnetic Elite.
Follow the same procedure for attaching rear stabilizer.
Step 1: Attaching front and rear stabilizers
Fig. 1
5
Step 2: Attaching the Spindle Bar
Insert the Spindle Bar (No. 38) through the Right Connecting Tube (No. 55) into the main frame,
into Left Connecting Tube (No. 24). Put a D Shaper Washer (No. 33) and a Spring Washer (No. 32)
on either side of the Spindle Bar and tighten both ends using the Hinge Screws (No. 31).
2 – “D” Shaped Washers
(No. 33)
2 – Spring Washers (No. 32)
2 – Hinge Screws (No. 31)
Insert the Right Hinge Bolt
(No. 42) with Arc Washer
(No. 74) through the
Connecting Tu b e (No. 5)
and screw it through the
Crank (No. 76) until
completely tight. Put
Spring Washer (No. 6) on
and secure the Right Hinge
Bolt (No. 42) with the Right
Lock Nut (No. 79) until
tight. The Spring Wa s h e r
(No. 6) has to be
completely flattened.
1 – Right Hinge Bolt (No. 42)
1 – Left Hinge Bolt (No. 1)
2 – Arch Washer (No. 74)
2 – Spring Washer (No. 6)
1 – Right Lock Nut (No. 79)
1 – Left Lock Nut (No. 7)
2 – Connecting Tube (No. 5)
Repeat this procedure for the left side.
ATTENTION:
The Right and Left Hinge Bolt (No. 42 & No. 1) must fully penetrate the
nylon ring inside the Connecting Tube (No. 5) and the Right and Left
Crank (No. 76 & No. 83). This will ensure the stability and durability of
your Orbitrek Magnetic Elite.
In order to install hinge bolt properly, keep it perfectly straight as the bolt goes through the pedal
tubing and the crankshaft. If the hinge bolt is connected to the crankshaft at an angle, damage to
both the hinge and the crankshaft may occur.
CAUTION: MAKE SURE ALL THE BOLTS AND NUTS ARE TIGHT PRIOR TO WORKOUT.
#1: LEFT #42: RIGHT
Fig. 2
CORRECT
LOOSE BOLT
ANGLED BOLT
79 6 76
5
74
42
Gap
