Owner’s Manual
4
II. Attaching front and rear stabilizers
Turn the OrbiTrek Pro on its back so that the main frame is upside down. Locate the front and rear
stabilizers which are clearly marked FRONT and REAR with blue stickers. Attach the front and rear
stabilizers (2F & 2R) to the main frame using:
• 4 - 3/8” x 60 carriage bolts (41)
• 4 - 3/8” arch washers (42) and
• 4 - 3/8” acorn nuts (43).
Place the Front Stabilizer with the dimpled square holes facing up toward you. Take two of the carriage
bolts (41), and pass them down through the dimpled holes and through the stabilizer support located on
the unit. Slip the two arc washers (42) over the threaded portion of the carriage bolts. Attach and firmly
tighten down the acorn nuts (43).
Follow the same procedure for attaching the Rear Stabilizer.
Once both stabilizers are firmly attached, turn the unit over to its upright position.
Notice
that the front stabilizer (2F) has rolling front end caps (22) for moving your OrbiTrek Pro.
2R
2F
41
42
43
1
41
42
43
22
Fig. 1
FRONT
REAR
