P80000_M52098_Rev_June2020
ASSEMBLY & OPERATIONS MANUAL
PAGE 3
ASSEMBLY:
continued
STEP 6: Position the spreader laying forward on
wheels and hopper as shown in Figure 6.3.
Figure 6.4 - Remove the cross brace by removing
two bolts and lock nuts. Keep the hardware for
reinstallation in step 6.6.
Figure 6.5 - Attach the lower frame rest to the
hopper assembly utilizing the two top holes. Two
(6.1) 1/4”x 2-1/4” bolts and two 1/4-20 nylon lock
nuts (6.2) are needed to make the assembly.
Install but do not tighten the lock nuts until next
step.
Figure 6.6 – Complete the rest assembly by
utilizing the two bottom holes. Reinsert the two
1/4”x 2-1/4” bolts that were removed in step 6.4
through the rest, then the frame, then the cross
brace. Install two 1/4-20 nylon lock nuts (6.2) and
now tighten all four lock nuts.
Figure 6.4 – Remove cross brace by removing 2 bolts and
lock nuts
6.1
6.2
4 x
4 x
Figure 6.3 - Starting Position – Attach Rest to Frame
Figure 6.5 – insert bolts and loosely tighten lock
nuts
6.2
Figure 6.6 – insert brace and tighten bottom lock nuts
6.2
