Install Ventilated Shelves
• Place the Shelf wires over the Shelf Bracket notches. Install the
Shelf with end wires inside the Brackets. Lock the Shelf into place by
pressing down on the middle of the Shelf and pushing toward the wall.
NOTE:
If installing two Ventilated Shelves side-by-side to create
one 4' Shelf, the two Shelves will share the middle Shelf Bracket.
Install Closet Rods
• Insert the Closet Rod Holder into the slot in the bottom of the
Ventilated Shelf Bracket.
• Tap the End Caps into both ends of the Closet Rod. Snap the
Closet Rod into the Closet Rod Holder. If installing Closet Rods that
share a Closet Rod Holder, only tap End Caps into the non-joined
ends of each Closet Rod.
Install the Bracket Covers
• Left and Right Bracket Covers are not interchangeable. Place the
outer edge of the Bracket Cover over the outer edge of the Ventilated
Shelf Bracket. Push down from the back to the front to snap the
Bracket Cover in place.
Install Top Track Cover
• Start with the long pieces first. Place the bottom of the Top Track
Cover into the bottom of the Top Track, then ease the top of the Top
Track Cover into the top of the Top Track. For smaller areas, measure
and cut the Top Track Cover with scissors to fit. Do not overlap
segments of the Top Track Cover.
4' Closet Kit
©2020 The Container Store Inc. All rights reserved. 47154 3/20
TIP
Ventilated Shelves have a top and a bottom. The middle support wire is
connected to the bottom of the Shelf.
C
D
D
E
F
E
F
C
