The Fire Beam firebeam, User Manual

Note:

if you break the beam whilst it’s auto aligning it

will automatically abort, reset by pressing the 

left back

button and pressing 

enter

to re-start auto alignment

the alignment could take up to 30 minutes or more
depending on how much aligning is required. Once com-
plete you will see a  Align Complete notification, simply
press the 

left back

button to exit and your 

fire

beam is now

ready and commissioned

you will now see this screen. Air Quality may fluctuate
slightly around a couple of %.above and below 100

first you will see the signal power readings  and receiver
sensitivity drop if the received signal reading is over 100%.
once at 100%  or if the reading is under 100% the

fire

beam

will automatically move its X and Y axis until it is positioned
on the reflector. (

This operation could take 30 minutes or

more)

step 

four.

testing

to test that the firebeam is aligned correctly you will need to carry out two tests.

Your

fire

beam has now been commissioned and tested.

1. a filter test for ‘

Fire

’

place the filter provided over the eyes of the 

fire

beam.

having done this (after 10 seconds) the 

red 

fire LED will flash on

both the head and on the controller and the word FIRE will
replace NORMAL on the low level 
controller display

2. a reflector test, to check that the beam is reflected
back from the reflector

cover the reflector completely within one second. If the beam is 
correctly targeted on the reflector a fault condition will occur (after
10 seconds). A amber  LED will flash on both the head and on the
controller, the word FAULT will appear 
in the display 

10