step
three.
commissioning
to commission the fire beam you must follow the simple procedure below
1.
do
NOT
put up the reflector or
COVER
it if in place already!
2. power up the unit - you will see
then the screen will default to
3. access the menu system by pressing
enter
4. scroll through the menus until you get to commissioning
5.
enter
commissioning and
enter
pre-alignment
(pre alignment is probably the most important part of commissioning)
6. you will see this screen
received signal
P = pre-alignment
signal power
receiver sensitivity
X (horizontal)
motor position
Y (vertical)
motor position
6
Summary of Contents for firebeam
Page 1: ...user guide issue 0025 05...
