step
three.
commissioning
to commission the fire beam you must follow the
simple procedure below
1.
do
NOT
put up the reflector or
COVER
it if in place already!
2. power up the unit - you will see
then the screen will default to
3. access the menu system by pressing
enter
4. scroll through the menus until you get to commissioning
5.
enter
commissioning and
enter
pre-alignment
6. you will see this screen
7. signal power starts at 10% and the receiver sensitivity starts at
5% and automatically increases until a received signal from the
blank wall without the the reflector of between 5 and 7% is
achieved, it will then stop
8.
Now press enter and confirm by pressing the right key. The
manual alignment menu will appear press
enter
to enter.
received signal
signal power
receiver sensitivity
received signal
X (horizontal)
motor position
Y (vertical)
motor position
press
enter
in
pre-alignment and then
confirm by pressing the
right
key
press
enter
to
enter manual
mode
