3. INSTALL THE WORKSTATION BASIN
a) A wood support frame (cleat system) will need to
be built and installed into the cabinet(s). This frame
will support the weight of The Galley Workstation.
NOTE:
Clips are NOT to be used.
b)
Construct the support frame so that the inside
dimensions of the frame are 1/2" larger than the
Basin’s inside width and length dimensions. Please
refer to pages 1-4 for your Galley dimensions.
NOTE:
For a Galley Works DryDock™, the
support frame must be built with 1” x 2” boards so
that there is no interference with any undercounter
appliances.
1. CONSTRUCT SUPPORT STRUCTURE
**IMPORTANT**
Place the support frame into the cabinet flush with
the front of the cabinet. This will ensure that there is
the minimum 3” plumbing space from the back of the
frame to the cabinet wall needed.
The support frame must be installed 1/16” lower than
the top of the cabinet.
NOTE:
Use a level to ensure that the support frame is
installed level in the cabinet. Once installed, the top
of the Basin Flanges will be flush with the top of the
cabinet.
Attach the support frame to the interior walls of the
cabinet.
2. ATTACH THE SUPPORT FRAME TO THE
INTERIOR WALLS OF THE CABINET
6
1” x 6” HARDWOOD BOARDS ARE RECOMMENDED
EXCEPT FOR DRYDOCK, FOR
WHICH 1” X 2” ARE RECOMMENDED.
OVERHEAD VIEW
a) Carefully place The Galley Basin into the cabinet
by resting the flanges on the support frame. All four
flanges should rest on the support frame.
b) Use a level to ensure that the flanges are level. The
top of the flanges should be flush with the top of the
cabinet.
c) Position the Basin so that it is perfectly square
within the cabinet.
