EN
User Manual
www.handy-tools.us
Mini drills
The HANDY DRILL that just bought is a grinder, engraver and drill. Especially designed for
home, manicure/pedicure and DIY (Do-It-Yourself) use. With this tool you can make small
boreholes, can do grinding, polishing or even cutting. Maximal borehole size is Ø3.2mm.
You can easily connect the accessories and the removing also not need any savvy.
Usage
Hold the tool like a pen. Make sure do not press the collet lock button (B) in use, because
its cause serious damage in the drill. The drill can be switched on by turning the button
of the device’s end (D) [The type of 10114 drill can be switched on by use the potmeter of
speed.] The rev setable by the ON/OFF turnable switch. Turn up the knob for the higher
rpm.
attention
•
Please check that the wires are in good condition before use.
•
Do not use in rainy, humid or moist enviroment!
•
Keep away (and never use) from flammable gases or liquids.
•
Do not force the drill! If you feel or hear is slowing down or stop, please turn it off or
finish the work.
•
Please, wear your safety glasses during the use of device!
•
Do not touch the collet and any moving part (even slow rpm) because it causes
injuries!
CHange of aCCessories
1.
Turn off the device and make sure is completely stopped. (For the higher security and
avoid the the injuries remove the power cable from the wall socket!)
2.
Push and hold the „B” button and turn the collet until the button descends!
3.
When the collet has locked, turn the closing cap and remove the accessory/head. The
desired diameter can be set by the turning of the closing cap!
4.
Place the new accessory or head onto the collet and screw the closing cap to close,
while the LOCK BUTTON is held all time.
5.
Release the LOCK BUTTON!
