Page 9
REPLACEMENT OF LINE
Follow these steps to replace the cutting line.
•
Stop the engine.
• Lay the trimmer on the floor so that the cutting head is facing up.
•
Squeeze the head on both side
s
at right angles to the eyelets.
•
Remove
the
empty spool being careful not to lose the spring
behind
the head.
•
Clean the head thoroughly and inspect for any worn or damaged
parts.
To reload the spool with line:
•
Cut two lengths of spare line 3 metres long.
•
Position each line in the two holes located in the centre of the
spool and wind in the direction of the arrow on the spool.
•
Wind the line on until you have about 15cm left.
•
Secure the lines into the slots on the spool.
•
Replace the spring and reposition the spool with the two cords in
the eyelets.
•
Close the spool making sure it snaps together.
•
Release the lines from the spool by sharply pulling each line
while pushing down on the spool.
Summary of Contents for THBC43
Page 12: ...Page 12 PARTS DIAGRAM DRIVE UNIT ...
Page 14: ...Page 14 PARTS DIAGRAM ENGINE ...
