2013-04-03
6
OPERATION:
1. Cut the logs for splitting to 23” or less to fit into the splitter.
2. To enable the hydraulic jack ram -- pump the foot pedal of the hydraulic pump to raise the
splitter workbench.
3. Pull both of the wedge release pins out of the holes in the post, and lower the wedge to a
height slightly more than the length of the log.
Note: Make sure the wedge release pins are firmly seated in the post holes before
continuing.
4. Place the log securely on the splitter workbench.
5. Keeping the log stable and your hands out of the way of the wedge, use the hydraulic foot
pedal to raise the log up tight against the wedge.
6. Keep your hands away from the log and log splitter, continue with even strokes of the
hydraulic foot pedal until the log is split.
7. Remove the wood pieces and clear the area of any debris.
8. To lower the splitter workbench first release the hydraulic pump by treading on the release
lever on the jack, then apply downward pressure to the workbench.
