Filter Re-Assembly
Instructions
WARNING
RE-INSTALLING CARTRIDGES
1. Flush and drain any dirt or debris
2. Flush any dirt or debris from the upper
3.Carefully replace the cartridges over
the hubs on the bottom
seal plate.
4. Place top manifold securely on top
from the bottom of the lower filter body.
upper body and from around the manual
air relief area.
of cartridges, aligning the return pipe with
the port in the manifold.
CLEAN SEAL RING AND SEAL SURFACE
1. Remove filter tank seal
2. With a clean cloth, wipe the lower filter
3. With a clean cloth wipe the upper filter
Notice: • Do not use any petroleum
solvents
to clean filter components.
• Do not lubricate seal.
body seal surface and clean seal of all dirt
and debris. (Fig 4) Do not use a solvent.
body seal surface.
WARNING
This product should be installed
and serviced only by
a qualified pool
professional.
1. Place the metal reinforced seal
on lower
filter body. (Fig 4) Place
upper filter body on metal reinforced
seal and lower filter body in a
position which allows all operation
and safety labels to be clearly visible
and the upper filter body to be
centered on the lower filter body.
Press down firmly and evenly on the
upper filter body to seat the seal.
(Fig 7)
2. Replace the filter clamp around
3. Insert clamp bolt through the
Never rely on hand tightening of
4.
CLAMP WITH HAMMER OR METAL
TOOLS.
5.
the upper and lower filter bodies.
Hold the clamp ends to position the
clamp on the filter bodies with the
clamp ends adjacent to the safety
and operation labels on the filter
bodies. (Fig 7)
clamp ends and thread the clamp
nut onto clamp bolt with rounded
end of the nut (Fig 8) towards the
ends of the clamp.
clamp nut to clamp bolt. Using a 3/4”
socket on a torque wrench, torque
clamp nut to clamp bolt to 150 inch-
lbs. (Fig 9)
DO NOT HIT OR STRIKE
“Starting the Pump and Filter
System” (Page 5).
BODY AND CLAMP RE-
ASSEMBLY
VACUUMING POOL
Vacuuming can be performed
directly
into the filter whenever
needed. Clean cartridges after
vacuuming, if required.
DRAIN
PLUG
LOWER
FILTER
BODY
ALIGN
LABELS
Figure 7
Clamp bolt
Rounded end of nut
Figure 8
Tighten clamp
bolt and nut
using a
torque
wrench to 150
inch-lbs.
Figure 9
9
