The t.mix xmix 802 USB, User Manual

5 

Connections and controls

1

[MIC]

Balanced XLR mono input to connect a microphone.

2

[LINE]

1/4" phone input to connect a line level audio source (keyboards, drum

modules etc., balanced or unbalanced).

3

[80 Hz HPF]

High pass filter to attenuate rumble noise and other low frequency interfer-

ence.

4

[GAIN]

Rotary control to adjust the input level.

5

[EQ]

3-band EQ for treble 

[HIGH]

, mids 

[MID]

 and bass 

[LOW]

.

6

[AUX]

Rotary control to adjust the signal portion to be sent to the 

[AUX SEND]

output to e.g. create a monitor mix.

7

[PRE / POST]

When this switch is pressed, the signal portion set with the 

[AUX]

control is

not affected by the channel fader (

[PRE]

). When the switch is not pressed,

the AUX signal is not subject to the channel fader (

[POST]

).

8

[FX]

Rotary control to control the signal portion, which is sent to the 

[FX SEND]

output.

9

[PAN]

Rotary control to arrange the channel signal within the stereo panorama R /

L.

10

[PFL]

switch

With this switch pressed, the channel signal is unaffectedly by the setting of

the channel fader and the internal effects section and present at the outputs

[PHONES]

 and 

[CR OUT]

 to adapt the values). The switch does not affect the

signal at the outputs 

[MAIN OUTPUT]

 and 

[REC OUT]

.

11

[PFL]

LED

This LED lights on activated PFL function.

12

[PEAK]

The LED lights up on channel overload. If this happens, turn the 

[GAIN]

con-

trol to the left until this LED is extinguished.

13 The channel fader sets the strength of the channel signal in the overall

signal.

Mono channel strip

Connections and controls

mixer

10