4
7
6
5
3
2
1
Modular Shelter System
Quick Pitching Instructions
© William Penney The Theory Works® 2014 All Rights Reserved.
2 | 2
Connect
walking
poles with
Pole Union
Connect poles using pole union
1
Position
Groundfloor™
Lay out groundfloor™ and peg down
Use peg points underneath for triple elements
2
Peg down
Elements
Connect sidewalls
together using hook/
loop tape
3
Peg down the bottom
edge of the sidewalls
Use peg points
underneath for
triple elements
Separate sidewalls at
hook/loop tape
3
Peg down bottom
edge of the roof
Postion sidewalls
under Groundfloor™
or outside as required
Use peg points
underneath for
triple elements
Pitch using
walking poles
Place all centre rings on one walking pole tip
4
Place other walking pole tip in ground
through centre hole in Groundfloor™
Lengthen
walking poles
Extend walking poles,
leaving roof and
sidewalls slightly loose
Extend walking pole
until roof is tight
Tighten
sidewall guys
Peg out sidewall guys
and tighten so that
each roof corner is
directly above the
sidewall peg
5
Adjust pitch
If the edges of the
roof and the roof are
not tight, the pole is
too long. Shorten the
pole and re-tighten
the sidewall guys
If the edges of the
roof are tight, but the
roof not tight, the pole
is too short. Extend
the pole and readjust
the sidewall guys
Peg out
roof guys
Peg out the roof guys and tighten evenly
6
Adjust and fit
Rain Ceiling™
Allow 1 extra side for each vent
7
Attach to the top of the shelter
using hook/loop tape
To create a vent, position two sides of the
Rain Ceiling™ over 1 side of the elements
Fit Insect
Ceiling™
Place around the pole, with the hook/loop
tape facing outwards, then fasten the zip
Attach around the edges using the hook/
loop tape. Make small folds in the insect
mesh, so that it fits evenly to the elements
Tighten the draw cord so that the mesh is sealed
