P.11
3
(Upper)
Main Wing
16
2.5mm
Top View
Left
Right
Wing Tube
Ø
22x817mm
Note : It is recommended that the wing tube stays with the left wing. Removal of the wings could be achieved
by removing the right wing machine screw, the right wing then the left wing with wing tube. If removal of wing
tube from left wing is also required, it is recommended that instead of applying self-tapping screw in step 3,
you pre-tap with M3 thread cutter and apply M3 machine screw.
1
2
3
Step
Step
Step
Step 2. Install the right wing to the center wing cabane by inserting the wing tube (now attached to the
right wing) through the cabane, then install the left wing.
S t e p 3 . M a k e s u r e t h e w i n g s a r e r e s t i n g a g a i n s t t h e c e n t e r w i n g c a b a n e t i g h t l y. L o c a t e t h e p r e -
d r i l l e d 2 m m h o l e a t t o p o f l e f t w i n g , a n d d r i l l a l o n g w i t h 2 . 5 m m d r i l l b i t u n t i l i t p a s s e s t h r o u g h t h e
w i n g t u b e . A p p l y t h e PA 3 x 2 2 m m s e l f - t a p p i n g s c r e w .
≈
164mm
≈
380mm
d3 x D7mm
Washer
PM3x22mm
Screw
1
2
PA3x22mm
Screw
1
PM3x22mm
d3 x D7mm
Washer
PAx22mm
d3 x D7mm
Washer
Top View
Step 1. Insert the aluminum wing tube (
Ø
22x817mm) with the pre-drilled hole end into the right wing (upper).
Align the lines marked at the wing root and wing tube, then apply the PM3x22mm machine screw through the
pre-drilled hole on top of the wing. (Please confirm the alignment of the hole by putting a 2.5mm diameter rod
through the pre-drilled wing hole before applying the screw.) The hole on the wing tube is pre-thread, do not
over tighten the PM3 screw, the set up is for future removal of the wing.
