The World Models Manufacturing ULTIMATE - 40S, Instruction Manual

P.11

Adjust the control throws as shown in the diagram. 
These throws are good for general flying. 

You can 

adjust according to your personal preference.

Elevator

Rudder

Control Throws

Ailerons 

5mm

5mm

30mm

30mm

10mm

10mm

C.G.

23

81mm

3 2 in.

.

The ideal C.G. position is 81mm (3 2 in.) behind
the leading edge measured at top wing center line.  
In order to obtain the C.G. specified, add weight to 
the fuselage or move the battery position.  Check 
the C.G. before flying.

.

Important Safety Precautions

9

Warning!

# First time flyer should never fly by himself / herself.  Assistance from experienced
   flyer is absolutely necessary.

# Pre-flight adjustment must be done before flying, it is very dangerous to fly a badly 
   pre-adjusted aircraft.

#                            is specially designed to be powered by 

 engine, using a more powerful engine does not mean better performance.  In fact, 

over powered engine may cause severe damage and injuries.

# Make sure the air field is spacious, never fly the plane too close to people and never
   get too close to a running propeller.

# If you find wrinkles on the covering as a result of weather changes, you can use hot 

iron to remove the wrinkles.   Please begin with lower temperature setting and 
gradually raise the temperature until the wrinkles are gone.  Too hot an iron may 
damage the covering.  Don't use hot iron near the seams or edges, hot iron will

   melt the glue and shrink the covering at the same time, causing the seams to pull away.

# Check and re-tighten up all factory assembled screws, use thread locker if necessary.

2C 0.40-0.46 or 4C 0.48-0.56

http://www.theworldmodels.com/para/instruction/instructionManuals.php

A009SPO26741109