P.3
Main Wing
1
Aileron Servo
2
Main Wing
3
Bottom View
Bottom View
Pre-glued
Completed
Please dry fit wing joiner into left and right wing to make sure they fit with the
proper dihedral angle, mark the wing joiner if necessary. Apply epoxy glue to
both sides of all surfaces in contact. Use a stick to apply the glue to inner side
of wing joiner sleeve, and apply the glue to wing joiner before putting them
together. Wing joiner not glued properly will lead to wing failure and plane crash.
Lead to Aileron Servo
Peel off shaded
portion covering film.
Main Landing Gear Pre-installed
KA3x14mm
1.5mm
TWM PL8210010
CLEVIS WRENCH
Tri-Horn
M3x14mm
Fuel Tube
Ø6x5mm
Clevis
PB2x16mm
Pushrod Ø1.8 x 110mm
Straper
Fuel Tube
6x5mm
Ø
PWA 2 x 8mm
1mm
PB2x16mm
Screw
6
8
PWA 2x8mm
Screw
Ø1mm pilot holes for World Models tri-horn are pre-drilled. Please look for pin-hole
marks at under side of control surfaces.
Wing Joiner
6x20x309mm
