COMPARTMENT CONTROL
Individual temperature controlled compartments enable a variety of fridge/freezer
combinations and also allow either compartment to be shut off to save energy. Temperature
setting range: -20°C ~ +20°C, -4°F ~ 68°F Plug in the DC or AC power cable. Use the ON/OFF
power button located on the electronic thermostat to power on the fridge. The LED display on
the control panel will light up and the interior temperature will be displayed.
Standard voltage input range: DC12V / 24V, maximum not exceeding DC30V
Start-Up
Connect to the power source.
If the refrigerator is on ‘standby” mode, the "—"symbol will be displayed in the middle of the
display screen after the refrigerator completes the self-test.
Press and hold “ON / OFF” button for 2 seconds to complete the start-up procedure. After start-
up is finished, the digital screen will display current mode and temperature in the
compartment. Approximately after one minute (factory pre-set) the refrigerator turns the
working mode on and the compressor starts refrigeration to the desired temperature.
To turn the refrigerator OFF - press and hold the “ON /OFF” button for 3 seconds when the
control panel is unlocked.
Control panel locking and unlocking
If the control panel is locked (the child lock icon in the bottom right corner of the display is ON),
press and hold the "UP / DOWN" button for 3 seconds to unlock it.
The panel will be automatically locked again if no command was received within 20 seconds.
Temperature setting
When the control panel is unlocked, press the "UP / DOWN" button to adjust the temperature.
Each time you press the button the desired temperature changes by one degree. You can do it
quicker by simply holding the button.
The setting value will be saved automatically after five seconds.
Single and Double Temperature Zone
The fridge automatically identifies the temperature zone.
With the middle partition installed - it is a “Double Temperature” zone. Removing the middle
partition changes it to a “Single Temperature” zone. You can adjust the desired temperature for
both scenarios.
Operation mode setting
When the control panel is unlocked - press the "SET" button to switch the compressor working
mode between "ECO” (economic) and “MAX” (maximum).
"ECO" mode is to save energy and power. “MAX” mode is for fast cooling.