“Low Voltage Protection”
Your fridge can detect if the battery voltage is lower than the set value and will automatically
turn off the compressor to prevent over discharging the battery. In this case the screen will
display "E1" error code. When the voltage capacity of the battery is back to normal the
refrigerator will automatically turn the working mode one after one minute.
Factory pre-set is "Medium". To change it - follow the next steps:
Unlock control panel.
Press and hold the "SET" button for three seconds, release it after hearing the buzzer "Di”, and
then press the "SET" button again. Choose the desired option between "L, M, H" by pressing
the “UP/DOWN” button. Refer to table.
WARNING!
If your refrigerator turns the battery protection function ON right away – check your power
supply voltage capacity and verify if the “Low Voltage Protection “settings set too high or/and
check your DC power supply wiring for a low current.
We advise to set the protection level “H" for car operation of the fridge.
CLEANING and MAINTENANCE
Disconnect the power.
Wipe the refrigerator with a wet cleaning cloth.
Don’t spray it with water directly to avoid damaging electrical components.
Make sure your fridge is always clean and dry to avoid any problems with smell and moisture.
Battery protection
12 V turn off
12 V Turn on
24V turn off
24 V Turn on
Low grade - L
9.6V
10.9V
21.3V
22.7V
Medium - M
10.4V
11.7V
22.8V
24.2V
High grade-H
11.1V
12.4V
24.3V
25.7V