ERROR CODE
In a case of malfunctioning check the error code in the following, resolve the issue, unplug the
power and plug it in again. The compressor cooling mode will start to work after one minute.
TROUBLESHOOTING
Start-up Problems
1.
Check the power. Check if the fridge is “ON”.
2.
Check voltage.
3.
Check battery / refrigerator connection.
4.
Check the fuse.
5.
Check temperature settings.
Operation
1.
Overloading the refrigerator.
2.
Incorrect temperature setting. Settings are set too high.
3.
The door is not closed properly.
4.
The door seal (sealing ring) is damaged.
5.
Poor ventilation.
6.
The outside temperature is too high.
Other issues
Sound of "water circulating" inside the fridge is normal and is caused by the flow of refrigerant.
A reason of relatively higher noise level during start-up can be an unleveled surface or
obstructions creating vibration noise. During start-up the motor accelerates to achieve required
speed, so you may hear some additional noise which will come down to normal operating level.
Water drops inside the fridge may happen due to condensation
.
Error
Problem
Solution
EO The temperature sensor is
damaged
Check or replace the temperature
sensor
E1
The voltage is too low
Check the input voltage / Adjust the
battery protection level
E2 DC fan over-current cut-out
Check the cooling fan
E3
Compressor is not starting
normally
Turn off the power and wait for 30
minutes
E4 Abnormal compressor speed Adjust compressor operation mode
(MAX/ECO)
E5 Module temperature too high Move the refrigerator to a ventilated
place