Replacing Damaged Hard Drives
you can easily replace a damaged hard
g your data secure with the system’s
ard Drive Damage
display warning message also the system beeps.
3.
Slide a new hard disk into the tray and fasten the screws.
n when the HDD is accessed.
the system beeps and/or an email notification is sent
3.
Follow the steps mentioned above to replace the failed hard disk.
4.
The system automatically recognizes the new hard disk and starts the
If you are using RAID 1, RAID 5, or RAID 6
drive in the Thecus N7700SAS while keepin
automatic data recovery.
H
When a hard drive is damaged and data in the RAID volume, the system LCD will
Replacing a Hard Drive
To replace a hard disk drive in the N7700SAS:
1.
Remove the tray with the damaged hard disk.
2.
Unscrew the damaged hard disk and remove it from the tray.
4.
Insert the hard disk tray back into the N7700SAS until it snaps into place.
You can also lock it with a key if desired.
5.
The LED blinks gree
RAID Auto-Rebuild
When using RAID 1, 5, 6, or 10 on the N7700SAS, you can use the auto-rebuild
function when an error is detected.
1.
When a hard disk fails
to specified receivers.
2.
Check the LCD to see which disk has failed.
auto-rebuild sequence to resume its status before the hard disk crash.
116
