Doc.Ref
TgbVpn25x_en
Doc.version
1.2 – Nov.2004
VPN version
2.50
IPSec VPN Client User Manual
Property of Sistech SA - © Sistech 2004
10/10
the public (network side) address of the gateway
the preshared key you will use for this tunnel (this preshared key must be the same in the gateway)
the IP address of your company LAN (e.g. specify 192.168.1.0)
4.2.3
Step 3 of 3
The third step summaries your configuration. Other parameters may be further configured directly via the main
interface (e.g. Certificates, virtual IP address, etc..)
4.3
Tunnel configuration (main window)
4.3.1
How to create a tunnel?
To create a VPN tunnel from the main window (without using configuration wizard), you must follow the following
steps:
1.
Right-click on 'Configuration' in the tree list window and select "New Phase 1”
2.
Configure Authentication Phase (Phase 1)
3.
Right-click on the new Phase 1 in the tree control and select “Add Phase 2”
4.
Configure IPSec Phase (Phase 2)
5.
Once the parameters are set, click on “Save & Apply” to take into account the new configuration.
That way the IKE service will run with the new parameters