ECHO PELLET E.I. II
PELLET HEATER
15
FIGURE 9
FIGURE 10
START-UP AND OPERATION
A. Filling the Hopper and Start-Up
CAUTION
: Fuel hopper lid must be closed before
operating the unit. The feed motor will not work if
the hopper lid is open.
DO NOT OVERFILL THE
HOPPER
! The Echo will hold approximately 50
pounds of pellets.
Open the top cover and fill the hopper with pellets
(see Figure 9).
Use good-quality pellets that give you a vibrant,
yellow flame with little or no soot. Poor quality
pellets will burn rich with black sooty smoke and
ash will accumulate quickly.
IMPORTANT
: The quality of pellet varies from
brand to brand. This will affect the efficiency of
your heater. We suggest that you try several brands
until you find one that provides a clean, efficient burn.
IMPORTANT
: The fire pot must be seated flush
and must sit even in the fire pot tray. Air leakage
around the fire pot will create a poor burn (see
Figure 10). Light the pellets in the fire pot using any
approved lighting fluid.
B. Lighting Instructions
The Echo E.I. has automatic ignition. As a result
you simply plug in the stove, fill with pellets and
push the low, medium or high button on the control
panel. When the button is pushed to low, medium or
SAFETY
SWITCH
TURNS OFF
PELLET
FEED
MOTOR
WHEN
PELLET
HOPPER
DOOR IS
OPEN
Summary of Contents for ECHO-COMSTOCK PELLET E.I. II
