ECHO PELLET E.I. II
PELLET HEATER
24
FIGURE 16 – ROUTINE STOVE CLEAN OUT
AND MAINTENANCE
The following is a step-by-step procedure to clean
out and maintain your pellet stove.
1.
Stove must be shut off and completely
cold before performing this
maintenance
.
2.
Open door; remove fire pot and clean-
out covers.
3.
Vacuum entire inside area, including
heat exchanger tubes (both sides), using
a pellet vac or shop vac.
CAUTION: Do not use a household
vacuum cleaner.
4.
Connect vinyl clean-out tube to pellet
vac or shop vac. (An adaptor must be
used to connect to a shop vac. These can
be purchased at hardware stores or home
centers.) Insert the clean-out tube down
between the heat exchange tubes, and
vacuum up the debris. Repeat the
procedure on the other set of tubes.
5.
Turn control knob to “clean” position for
about 45 seconds.
6.
Replace clean-out covers and fire pot.
The stove is now ready to use.
Summary of Contents for Echo Pellet E.I. II
