Hardware Manual COMBILOG 1020
102
Note:
The address “0” is reserved for transmission via
PROFIBUS. This address can therefore not be assigned to a log-
ger.
Note:
The address “127” is reserved for broadcast transmission
in the PROFIBUS-protocol (Level 2) and may only be assigned
for these cases.
Adjustment via interface, RS232 by means of the configu-
ration software:
In addition to the bus interface RS485, the datalogger
COMBILOG 1020
has an RS232 computer interface. By means
of the configuration software
COMBILOG.EXE
addresses can be
assigned and bus parameters can be adjusted via the RS232 in-
terface similarly as when using the RS485 interface.
Summary of Contents for COMBILOG 1020
