Hardware Manual COMBILOG 1020
104
11.3 Data Format
The datalogger
COMBILOG 1020
supports following data for-
mats:
Format Start-
bit
Data-
bit
Parity
bit
Stop-
bit
Length
of char-
acter
ASCII
PROFI-
BUS
MODBUS
8N1 1 8 N 1
10
X -
X
8E1 1 8 E 1 11 X X
X
8O1 1 8 O 1 11 X -
X
8N2 1 8 N 2
11
X -
X
8E2 1 8 E 2 12 X -
X
8O2 1 8 O 2 12 X -
X
Table 11.1 Supported data transfer formats
The data format 8E1 with even parity (E=even) corresponds to
the PROFIBUS-definitions according to DIN 19245, part 1, and is
supported by the datalogger both in the PROFIBUS-protocol and
in the ASCII- and MODBUS-protocol. This data format should
therefore generally be selected for the transmission.
For modem connections, which in most cases can be carried out
without a parity-bit, the second data format is available. This data
format is only supported by the ASCII-protocol and the MODBUS-
protocol.
The data format is defined via configuration software
COMBILOG.EXE
. If there are no other specifications, the default
adjustment is ”no parity”.
Summary of Contents for COMBILOG 1020
