Hardware Manual COMBILOG 1020
115
device identification (v...v)
length = 28 char
<vendor name>......................... ASCII ("Friedrichs")........10 char
<model name>.......................... ASCII ("COMBILOG") ......8 char
<hw-revision> ........................... ASCII ("xy.yy") .................5 char
<sw-revision>............................ ASCII ("xy.yy") .................5 char
x ... “M“
: monitor program
x … ”A”,“U“: universal program
x ... “T“ : calibration and test program
x ... “S“
: application specific program
y.yy :
version
device information (s...s)
length = 28 char
<location> ................................. ASCII...............................20 char
<serial number>........................ ASCII.................................6 char
<number of channels> .............. ASCII.................................2 char
status information (z...z)
length = 12 char
< channel status > .................... ASCII................................ 8 Char
< module status > ..................... ASCII................................ 4 Char
<
channel status
> =
K32..K29 K28..K25 K8..K5 K4..K1
Byte:
1 2 7 8
<
module status > =
M16..M13 M12..M9 M8..M5 M4..M1
Byte:
9
10
11
12
If the bit Kn in the channel status is set it indicates that an error
has occurred in channel n. A channel error is given when the
measuring value is outside of the linearisation, e.g. in case of a
sensor break down or of a short circuit of transmission.
Summary of Contents for COMBILOG 1020
