Hardware Manual COMBILOG 1020
22
3
INSTALLATION
3.1 Mounting / Fixing
The datalogger
COMBILOG 1020
has a snap-on mounting for in-
stallation on standard profile rails 35 mm (1.4 inch) according to
DIN EN 50022.
Installation on the DIN rail is performed by means of the four
straps on the rear side of the datalogger. First push the two
straps on the bottom behind the notch of the DIN rail and then
press the datalogger on the DIN rail until the two straps on the
top snap in.
In order to take the datalogger off the DIN rail slide the module
lateral off the rail or in case it is not possible lift the datalogger
slightly so that the straps on the top get off the notch and the
datalogger can be taken off easily by pulling.
Attention
: Refer to protection earth hints in chapter
3.5
!
3.2 Protective
System
The datalogger has an IP20 protective system. For outdoor instal-
lations datalogger
COMBILOG 1020
can be installed in a stain-
less steel shell type 9910, thus featuring IP65 standard.
Summary of Contents for COMBILOG 1020
