Hardware Manual COMBILOG 1020
42
Voltage Measurement
Two methods are available for voltage mesurement:
single-ended
and
differential
measurement.
With the single-ended type the voltage to be measured is con-
nected between an analog input (In+) and analog ground
(AGND). Differential measurements are realized by using two
analog inputs (In+ and In-). Measuring range is between 0 and
±10 V.
Note:
With
differential
measurements both voltages have to be
within 10 V referred to AGND (Common-Mode-Range).
It is recommended to connect the In- to A
GND
with a high ohmic
resistance.
Summary of Contents for COMBILOG 1020
