INSTALLING YOUR
ALLCLEAR
™
G2 FILTER:
Watch a video of the AllClear™ G2 Filter installation
online @
www.thepondguy.com/allclearg2
• Run the AllClear™ G2 Filter 24 hours a day.
• DO NOT operate the AllClear™ G2 Filter
with a pump larger than the maximum flow
rate indicated by the filter specifications.
Operating with a pump larger than
recommended can reduce the filters
effectiveness and cause damage to the
filter or UVC and will NOT be covered
under warranty.
• DO NOT operate during freezing
conditions. Disconnect, drain and store the
AllClear™ G2 Filter in a protected area.
Tools Required:
•
Shovel
•
Hacksaw
•
Flathead
Screwdriver or Nut Driver
Determine Filter Location
The AllClear™ G2 Filter is pressurized and
may be installed in any location outside of
the pond on a solid surface. Avoid locations
that are prone to water puddles or areas
where the filter could fall into the pond. It
is recommended to partially bury the filter
in the ground leaving only the filter top and
clamps exposed.
Mark Filter Location
Set the filter in the selected location and use a shovel
to mark an area slightly wider than the filter.
Excavate Hole and Insert Filter
Excavate the hole deep enough for the clamp on the
filter top to remain a few inches above the ground’s
surface, and then insert the filter. Be sure to position
the filter so the inlet and outlet are setup for easy
connection to your plumbing. Finish by backfilling dirt
around the filter to keep it in place.
15425 Chets Way | Armada, MI 48005
5
Pump
Pressurized Filter
Plumbing
