SAFETY
WARNING: FOR YOUR PROTECTION, ALWAYS UNPLUG THE UNIT FROM THE
POWER SOURCE BEFORE INSTALLING OR SERVICING. SHOULD THE UNIT
APPEAR TO BE NOT WORKING, DO NOT ATTEMPT TO REACH, REMOVE, OR
DISASSEMBLE BEFORE DISCONNECTING IT FROM THE POWER SOURCE.
1. ALWAYS use a properly grounded AC outlet. Do not immerse the LEDPro™ plug
in water or attempt to use a wet plug.
2. Provide a “drip loop” for the power cord. This is a loop in the cord below the level
of the receptacle or plug that prevents water from traveling along the cord in
the direction of the receptacle.
3. Be sure that a ground fault circuit interrupter (GFCI) is installed in the branch
circuit supplying the pond equipment.
4. NEVER remove the ground pin from the plug.
5. The LEDPro™ is not suitable for use in swimming pools, swimming ponds, or
other situations where humans may make bodily contact with the water. The
LEDPro™ may be used in or out of the water.
6. The power cable cannot be replaced. If the power cable becomes damaged, the
LEDPro™ should be discarded.
7. The LEDPro™ must be used with a transformer which is included.
IMPORTANT: The Pond Guy®, Inc. is not responsible for losses, injury
or death resulting from a failure to follow these safety precautions,
misuse or abuse of equipment.
TECHNICAL SPECS
MODEL
# OF LIGHTS
WATTAGE
ITEM NUMBER
LEDPro™ Rock Lights – 3 Pack
3
1/2 Watt
Per Light
120999
INSTALLATION
DO NOT TAMPER WITH POWER CORD.
LIGHTS MAY BE PLACED IN OR OUT OF WATER.
1) Plug the two-pin connector on the end of the Lights (B) into the Transformer (A).
Tighten plastic nut.
2) Place Lights (B) in desired locations.
3) Make sure Photocell (D) and Transformer (A) are located out of the water.
4) Plug the power cord into a standard 110 volt outlet with GFCI.
MAINTENANCE
Clean Lenses (C) regularly. Algae/debris may build up on the lenses and reduce
light intensity.
NOTE:
Do NOT use chemicals or household cleaning agents to clean your lights.
3
2
LEDPro
™
Rock Lights
3 Pack Light Kit
WARNING
!
• This unit may get warm when used in an open air
application, turn off power and allow unit to cool
before servicing.
• Operating the lights with missing or damaged covers
can result in risk of fire or electrical shock.
• Do not exceed the voltage and wattage indicated on
the transformer.
• Keep away from flammable materials and/or children.
• This light assembly has not been tested or designed
for use in swimming pools and hot tubs.
LEDPro™ - Rock Light – 3 Pack
•(A) Transformer
•(B) Light
•(C) Lens
•(D) Photocell
(B)
(A)
(C)
(D)
light
16' cord
plug
8”
16'
16'
Photocell
Transformer
6’
