TherAdapt
Adjustable Angle Bench (AAB-100/200) Instructions
Packing List:
(1)
Bench top component with suede Naugahyde
®
padding
(2)
Rectangular side pieces with
(4)
¼ -20 counter-sunk bolts each
(2)
Curved rectangular floor pieces
(8)
Thru-knobs with ¼ -20 threaded inserts
(8)
Nylon washers
1. Attach the curved, rectangular floor pieces.
Remove the (4) lower thru-knobs, attach floor pieces,
and replace thru-knobs.
Tighten securely before use.
2. Adjust the height.
To adjust, we recommend standing the bench on one
end, and removing the pair of knobs on the inner
surface of the upper rectangular sidepiece. The
combined height and angle adjustable pieces can be
lifted off and the appropriate height determined by
putting bolts through one of the four pairs of holes
drilled in the sides.
3. Adjust the angle.
The outermost, curved, rectangular side pieces
determine the angle setting. Remove the outer
pair of knobs and lift off the angle piece.
Note:
This piece must be lifted off completely to make
adjustments. The bench angles from a horizontal
setting using the bottom hole to a 10
°
, 15
°
, 20
°
,
25
°
, or 30
°
angle using the five ascending holes.
Tighten all knobs securely before using.
TherAdapt
®
Adjustable Angle Bench (AAB-100/200) Instructions: Page 1 of 1
