TherAdapt
®
Winged Back Insert (WBI-100/200/300) Instructions
Packing List:
Tools Needed:
(1)
Insert with
(1)
Head pad, and
(1)
Lumbosacral pad
(1)
7/16” open end wrench
(1)
Butterfly chest harness with
(4)
side release buckles and
(2)
straps
(1)
Wooden “Yoke” *
(3)
6” ¼ -20 carriage bolts *
(3)
4” ¼ -20 carriage bolts *
(2)
1 ¾” ¼ -20 hex head bolts *
* Included in Hardware Bag
(6)
7/16” ¼ -20 hex nuts *
(6)
Metal washers *
(3)
“Flower” knobs with ¼ -20 threaded inserts *
(2)
Thru-knobs with ¼ -20 threaded inserts *
(2)
Nylon washers *
The Winged Back Insert is designed to interface with the
TherAdapt
Adjustable Positioning
Chair and
TherAdapt
Bolster Chair only. Assemble, attach and adjusts as follows:
1. Assemble the Winged Back Insert:
A.
Select either the 4” (for up to 3” of seat depth
reduction) or the 6” (for up to 5” of seat depth
reduction) carriage bolts for use. (Keep the unused
set on hand.) Insert
(2)
of the bolts into the two
holes at the bottom of the insert. Place a metal
washer, followed by a nut, on each bolt and secure
it in place.
Important:
With a 7/16” wrench (not
included) tighten the nuts securely to “pull” the
square neck of the bolt into the wood on the front
side of the insert.
B.
Insert
(1)
bolt through the center slot. Place a
metal washer, followed by a nut, on the bolt and
secure it in place loosely until final position is
determined. Tighten as above once height
adjustment is finalized.
C.
Place a 2
nd
nut, followed by a metal washer, on the
bolt.
Note:
The greater the distance between the
nuts the shorter the seat depth on the Adjustable
Positioning Chair.
TherAdapt
®
Winged Back Insert (WBI-100/200/300) Instructions: Page 1 of 3
Tighten the nut
securely, pulling the
square “neck” of the
bolt into the hole.
