1
2
3
Klick
18
Filters
The filters keep large foreign objects in the rinsing water away from the pump.
These foreign objects may occasionally block the filters.
The filter system consists of a coarse filter, a flat fine filter and a microfilter.
After each washing cycle check the filters for residue.
•
Unscrew filter cylinder as illustrated and take out filter system.
•
Remove any residue and clean filters under running water.
•
Re-install filter system in reverse sequence and ensure that the arrow
•
marks are opposite each other after closing the filter system.
Spray arms
Limescale and contaminants in the rinsing water may block nozzles and
bearings on the spray arms.
Check outlet nozzles on the spray arms for blockages.
•
Unscrew the upper spray arm.
•
Remove the lower spray arm.
•
Waste water pump
Large food remnants in the rinsing water not retained by the filters may block
the waste water pump. The rinsing water does not get pumped out and covers
the filter.
In this case:
Disconnect the appliance from the power supply.
•
Remove the filters.
•
Scoop out water, use a sponge if required.
•
Using a spoon, prise off pump cover(as illustrated) until it clicks, then grip
•
the cover by the lug and first pull it upwards until it resists and then pull it
out forwards.
Check inner compartment and remove any foreign objects.
•
Place cover in the original position, press down and engage.
•
Install filters
•
Winterizing your Unit
Transportation (MG)
Empty the dishwasher and secure loose parts.
Drain the appliance according to the following steps:
Turn on the tap.
•
Close the door.
•
Switch on ON/OFF switch.
•
Select programme with the highest temperature.
•
The expected programme duration is indicated on the numerical display 8.
Press START button )”.
•
Programme sequence starts.
After approx. 4 minutes press the START button )” until 0:01 is indicated
•
on the digital display.
After approx. 1 min 0:00 is indicated on the digital display.
Switch the appliance off (and turn the tap off).
•
Transport appliance upright only.
(This prevents residual water from running into the machine control and
damaging the programme sequence.)
If the appliance is in a room where there is a risk of frost (e.g. holiday home),
empty the appliance completely (see Transportation).
Turn off the tap, disconnect supply hose and drain water.
•
1
2
