Page 9
1. In the base of the cabinet drill
1/16” tap holes at the locations
shown in Figure 10. Screw in
four 4.2 mm x 18 mm
screws
(provided with hood) leaving 1/4”
exposed.
2. If the hood is installed for
vertical discharge use Figur
e 11
to create clearance holes for
passage of the transition and
conduit. Dimension A in Figure
11 depends on the hood model
being installed and can be located
in the table above.
Figure 10
Figure 11
" " " " " " " "
"
" " " " " " " "
"
