English 9
Step 3: Unpacking, Moving
and Placing the Range
Remove all tape and packaging before using the
appliance. Please, recycle the packaging
material, as all THERMADOR
®
appliance
packaging material is recyclable. Never allow
children to play with packaging material.
1.
Remove the outer carton and packing materials from
the shipping pallet but leave the adhesive-backed foam
layer over brushed-metal surfaces, to protect finish
from scratches, until the range is installed in its final
position.
2.
The range has an approximate shipping weight as
shown in Chart A. It is recommended that the grates,
griddle plate, burner caps and oven racks be removed
to facilitate handling. This will reduce the weight as
shown in Chart A.
Do not remove the griddle
assembly
.
3.
The ranges are held to the pallet by four (4) bolts (see
). The front kick panel must be removed to
access the bolts in the front of the pallet (see
).
To remove the Kick Panel, remove the two screws
below the lower corners of the oven cavity and lift the
Kick Panel away from the two projections on the
range’s cast base (see also
--
The electric wire diagrams and schematics are
attached behind the kick panel, and should not be
removed except by a service technician, then
replaced after use.
CAUTION:
The unit is heavy and should be handled
accordingly. Proper safety equipment such as
gloves and adequate manpower of at least
two people must be used in moving the range
to avoid injury and to avoid damage to the
unit or the floor. Rings, watches, and any
other loose items that may damage the unit
or otherwise might become entangled with
the unit should be removed.
Hidden surfaces may have sharp edges. Use
caution when reaching behind or under
appliance.
CAUTION:
DO NOT
lift the range by the oven door's handle, as this
may damage the door hinges and cause the door to fit
incorrectly.
CAUTION:
Do not use a hand truck or appliance dolly on
the back or front of the unit. Handle from the
side only.
Chart A
30"
Range
36"
Range
48"
Range
Shipping Weight
351 lbs
(159 kg)
371 lbs
(168 kg)
499 lbs
(226 kg)
Weight without
packing materials
228 lbs
(103 kg)
270 lbs
(122 kg)
403 lbs
(183 kg)
Without doors,
burner caps, front
kick panel and oven
racks
185 lbs
(84 kg)
221 lbs
(100 kg)
318 lbs
(144 kg)
Figure 4: Remove Kick Panel
Remove screws
using a T-20 Torx
screwdriver.
Slightly push
panel up then out
once the screws
have been
removed.
X
scre
w
s
W
ire
D
ia
gra
m
