English 24
When installing against a combustible surface, a High Shelf
or Low Backguard is required. A THERMADOR
®
High
Shelf or Low Backguard must be purchased separately.
See clearances on
page 6
for more information.
When using the Flush Island Trim, THERMADOR
recommends a minimum 12” (305 mm) rear clearance to a
combustible surface (
see Figure 1, Cabinet Clearances
).
Clearances from non-combustible materials are not part of
the ANSI Z21.1 scope and are not certified by
CSA. Clearances of less than 12” (305 mm) must be
approved by the local codes and/or by the local authority
having jurisdiction.
High Shelf Assembly
1.
Remove protective plastic.
2.
Slide the shelf onto the backguard channel.
3.
Install the included (5) stainless screws along the
topside of shelf and (8) stainless screws into the back
of the shelf.
4.
Begin with Backguard Installation.
Backguard Installation
1.
Remove protective plastic.
2.
Depending on model, remove the (3) or (5) T-20 Torx
stainless screws in the front face of the included Flush
Island Trim, the (4) drill point screws securing the trim
to the side panels, and the (2) or (4) drill point screws
securing the piece to the back panel. Lift up to fully
remove.
3.
Align the back panel of the new accessory with the
flanges on the range side panels right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range.
4.
Make sure the backguard’s front face is outside the
flange on the front side of the range.
5.
Re-install screws in the new backguard’s front and
back panels.
6.
Re-install (4) drill point screws to secure the
backguard’s back panel to the side panels on the back
of the range.
Backguard Kit Model Numbers
Model
36”
48”
48” Steam
Low Back
PA36JLBG
PA48JLBG
PA48JLBSG
High Shelf
PA36JHSG
PA48JHSG
PA48JHSSG
Flush Island
Trim
Included on
Range
Included on
Range
Included on
Range
Figure 25:
Backguard Rear View
(12x) screws along the back
5x screws along the top
Figure 26:
Backguard Installation
High Shelf
Low Back
Flush Island Trim
(Included with range)
Mounts inside back panel flange
Mo
u
n
ts
in
si
d
e
si
d
e
p
a
n
e
l
fl
a
n
g
e
Mo
u
n
ts
in
si
d
e
si
d
e
p
a
n
e
l f
la
n
g
e
Summary of Contents for Professional PRO-HARMONY PRD36
Page 95: ...Español 31 ...
