Installation and connection
en-us
5
Old appliances
Valuable raw materials can be reclaimed by
recycling old appliances.
9
WARNING
CHILDREN MAY BECOME LOCKED IN THE
APPLIANCE AND SUFFOCATE!
BEFORE DISPOSING OF YOUR OLD
APPLIANCE:
■
Remove the door.
■
Leave shelves and containers in the
appliance to prevent children from climbing
in.
■
Keep children away from the redundant
appliance.
9
CAUTION!
REFRIGERANT AND HARMFUL GASES MAY
ESCAPE.
Do not damage the tubes of the refrigeration
circuit and insulation.
1.
Pull out the mains plug.
2.
Cut through the power cord.
3.
Have the appliance disposed of properly.
5
Installation and
connection
Installat
ion and c
onnection
Scope of supply
After unpacking all parts, check for any damage
during transport.
If you have any complaints, please contact the
dealer from whom you purchased the appliance or
our customer service.
The delivery consists of the following parts:
■
Built-in appliance
■
Fittings (depending on model)
■
Installation material
■
Instruction manual
■
Installation instructions
■
Customer service booklet
■
Warranty enclosure
■
Information on the energy consumption and
noises
Technical data
Refrigerant, cubic capacity and further technical
specifications can be found on the rating plate.
"Getting to know your appliance" on page 8
Installing the appliance
Installation location
The weight of the appliance may be up to 460 kg
depending on the model. The base must be
sufficiently stable and should not give. If necessary,
reinforce the bottom.
Built-in cut-out
The cut-out must fulfil these criteria:
■
min. 24" (610mm) deep
■
rectangular
■
stable – the side panels and the top must be min.
5/8" (16mm) thick and securely attached to the
bottom or wall
■
shortened side panels must be min. 4" (100mm)
deep
Side-by-side installation
Side-by-side installation is only possible as follows:
If you wish to install appliances in a different manner,
there must be a partition wall between them. This
partition wall must be min. 5/8" (16mm) in width.
