1751 Hurd Drive ● Irving, Texas 75038 ● (972) 580-0200 ● (888) 580-0202 ● Fax (972) 580-0277
URL: www.thermal-edge.com ● Email:
SP-ENG-211-000-14 Rev 1.8
25
|
P a g e
Appendix A
Wago Power Terminal Block Instructions
Scope: Instructions for connecting power wires to air conditioners equipped with a “Wago” power terminal
block.
1 - Remove cover from chassis using T25 Torx bit.
2 -The sequence of the connecting the wires is from LEFT TO RIGHT.
3 - Connect each wire as shown by lifting the lever and inserting the wire into the receptacle directly below.
Snap the lever down to secure the wire in place.
4
– If wires need to be removed, raise the lever directly above each wire to release it.
1. Line1
2. Line2
3.
NA
4. Ground
