9
10
User's Maunal
S
H
A
R
K
S
H
A
R
K
On the front of the case, you can find some LEDs and switch leads
(POWER SW*1, POWER LED*1, H.D.D. LED*1, RESET SW*1).
Please consult user manual of your motherboard manufacturer,
then connect these leads to the panel header on the motherboard.
These leads are usually labeled; if not, please trace them back to
the case front to find out their source.
-
POWER LED
connects to your M/B at the PLED
-
POWER SW
connects to the PWR connector on the motherboard.
-
H.D.D LED
connects to the 2-pin labeled HDD LED connector.
-
RESET SW
connects to the RSW connector on the motherboard,
-
SPEAKER
connects to the SPK connector on the motherboard
3.1 Case LED connections
Chapter3 Leads connection
2.7 Motherboard Installation
Unscrew the thumbscrews
on the tray and remove it.
1
Slide the motherboard tray
toward the drive to
remove it.
2
Place the motherboard
tray on a flat surface and
mount the motherboard.
When finish, place the
motherboard tray into the
case and slide it into
position.
2
