TM
Toughpower
700W / 800W
TM
Toughpower
700W / 800W
3. Power Connector Introduction
MODELS
Connector Type
Connectors & Cable length
700W
800W
20+4pin
ATX 12V 4pin
EPS 12V 8pin
Molex & FDD
SATA
PCI-E 8/6pin
4. Installation Steps
1 x 20+4pin Main connector
(500mm)
1 x ATX 12V 4pin connector
(500mm)
1 x EPS 12V 8pin connector
(500mm)
2 x Peripheral & 1 x FDD connectors
(500mm + 150mm + 150mm)
3 x
connectors
(500mm + 150mm + 150mm)
Peripheral
3 x S-ATA connectors
(500mm + 150mm + 150mm)
3 x S-ATA connectors
(500mm + 150mm + 150mm)
1 x 8/6pin PCI-E connectors
(500mm + 150mm)
1 x 8/6pin PCI-E connectors
(500mm + 150mm)
03
04
Cable
P/N Model
W0295 700W
W0296 800W
1
1
1
6
5
1
2
2
2
1
1
1
6
5
1
2
2
2
1. Open your computer case; please refer to the direction in your
case manual.
2. Install the PSU into the case with the four screws provided.
3. Connect the 24 pin Main Power Connector to your motherboard
and peripheral. If your motherboard uses a 20-pin
connector, detach the 4-pin attachment on the 24-pin connector.
4. Connect the 8-pin or 4-pin connector for the CPUs.
5. Connect other peripheral power connectors to devices such as
hard drives, optical drives, etc.
6. Close your computer case and connect the AC power cord to
the power supply AC inlet.
Note: The detachable 4-pin section cannot be used in place of a 4-pin +12V
connector.
Note: Make sure that your system is turned off and unplugged.
Disconnect the AC power cord from your old power supply.
20+4pin Main
Connector
4pin +12V CPU
Connector
8pin +12V CPU
Connector
SATA
Connector
Peripheral
Connector
Floppy
Connector
PCI-E (8 to 6)
Connector
6pin PCI-E
Connector
8pin PCI-E
Connector
