Thermaltake Toughpower 850 B, Manual

-Tough Atomic Energy 

Build for the Extreme-

ATX 12V 2.2 & EPS 12V 2.91 Version

ATX 12V 2.2 

 2.91 Version

& EPS 12V

Toughpower 850W Cable Management

Toughpower 850W Cable Management

-Tough Atomic Energy 

Build for the Extreme-

5.

 Trouble Shooting

C

ondition 1:

No DC output. The fan or fans are  motionlessCheck:

1-1 Is the AC inlet plug firmly plugged into the PSU inlet

      socket?

1-2 Is the wall socket, extension power cord, power strip 

      or surge protector in use, fully functional and wall power

      switch turned  'ON'?

1-3 Is the Main Board socket (24pin) plug fully and firmly 

      inserted?

C

ondition 2:

The fan or fans began rotating and then stopped. The system 

hangs without proceeding any further.

Check:

2-1 Are the peripheral connectors firmly plugged  into 

      accessory devices, such as the main hard  drive, CD ROM

       , etc?

2-2 If a plug has been inadvertently connected in an off-set or 

       reversed position, unplug the AC power source, reconnect 

       the offending connectors and then wait for 30 seconds 

       before replug in the AC power source and try again.

Note:

If the power supply still cannot or is still  unable to power up 

after following the above instruction, please send the unit back 

to your dealer or retailer for after  sales service.

19

18

4.4.3 Short Protection
     

 All outp ut toGND.

4.5 Environment:

o

o

4.5.1 Operating Temp. 10 C to +50C 

o

o

4.5.2 Storage Temp. -20 C to +70C

4.5.3 Operating Humidity 20% to 90%, non-condensing

4.5.4 Storage Humidity 5% to 95%, non-condensing

4.5.5 Operating Altitude 0 to 10,000 feet

4.5.6 Storage Altitude 0 to 50,000 feet

4.6 Hi-Pot: (Input/Output isolation)

4.6.1 Primary to Secondary
         3535vdc for 3 seconds
4.6.2 Insulation Resistance
     

Prima ry toear thgrou nd 500Vd c, 50 M ohm

  s Min.

4.7 CE Requirements

4.7.1 Conducted EMI
     

 1. Me et FC C: Cla ssB

 2. Me et CISP

  R 2 2:Cla ssB

 3. Me et BSM I: Cla ssB

4.7.2 Safety Standards
     

 1.Me etCU  L (U

  L 6095 0  ) 

 2.Me etTU  V EN60950

 3.Me etC  B (IE C 950)

  4. Me  et C

  E

 5.Me etCCC

4.7.3 Harmonic 
     

Me et IEC1000-3- 2, Cla ss D

O

4.7.4 MTBF at 25 C(demonstrated)

 Over 120 Khrs

170 X 140 mm