Thermaltake Toughpower 850 B, Manual

-Tough Atomic Energy 

Build for the Extreme-

ATX 12V 2.2 & EPS 12V 2.91 Version

ATX 12V 2.2 

 2.91 Version

& EPS 12V

Toughpower 850W Cable Management

Toughpower 850W Cable Management

-Tough Atomic Energy 

Build for the Extreme-

07

06

3.3 Installation Steps

T

o prevent electrical shocks, please disconnect the power cord 

from your existing power supply unit. Toughpower 850W Cable 
Management PSU has automatic Voltage Selector Which will 
automatically change to 100V-240V PSU .

I

nstallation Steps

3.3.1 Ground yourself to remove any static electricity by briefly 
         touching your PC cases and then, disconnect the power cord 
         from  your old  power supply  (if replacing  it)
3.3.2 Follow your computer case manual and disassemble the case.
3.3.3 Disconnect all the power connectors from the motherboard 
         and from the peripheral devices such as case fans, hard 
         drives,  floppy drives.  etc.
3.3.4 Remove the existing power supply from your computer case 
         and  replace it  with your  new Thermaltake 

Toughpower 

          850W  Cable Management 

PSU. 

3.3.5 Connect the power connectors to the motherboard and 
         peripheral devices (refer to the rest of this manual to match 
         the  various one-way  key-locked connectors  to the 
         motherboard  and accessories).
3.3.6 Connect the 6-pin PCI Express connector to PCI Express 
         graphic  card if  you need.

Note: Please read the user manual supplied with your graphic card
         for  detail usage  instructions.

3.3.7 Close the computer case.
3.3.8 Make sure your power supply switch is on "OFF" position, 
         and  connect the supplied power cord to your Thermaltake 
         

Toughpower 850W

Cable Management

 PSU. 

3.2 Embedded Socket and Modularized 
      Cable Management 

3.2.1 Embedded Socket and Modularized Cable Management:  
          The new embedded socket and modularized cable management 
          allows user use only the cables they need and improve the airflow
          in the chassis.
 

Embedded Socket and Modularized Cable Management Design:

3.2.2 Toughpower 850W unit: On the power supply, you will find sockets to connect
          with those cables. Users can choose which wire set they want to use for 
          devices, graphic card, fans, etc.  Inside the package, you will find the following 
          wire set:
         
         1. One 4-pin/8-pin +12V connector
         2. Eight 4-pin peripheral power connectors and two 4-pin floppy   drive 
              connectors
         3. Eight 5-pin S-ATA connectors
         4. Two 6-pin PCI-Express graphic card connectors

170 X 140 mm