5. Place hard drive into the body.
There are no tools required as
hard drive will sit on top of the
hard drive suspension system.
6. Push hard drive towards the
SATA PCB board to connect.
*Note: Make sure the hard
drive is connected securely
to the SATA connector. Top
panel may not close correctly
if hard drive is not connected
securely.
7. Place side panel over the
body and push upward to
secure.
8. Place metal security plate back onto the bottom of the main unit.
And secure 4 screws.
9. Place assembled main unit
onto the base unit and push
towards the back to secure.
Optional:
Package also includes 4 additional rubber feet to ensure proper
air exhaust should the unit is to be used without the base unit.
Instruction
Instruction
5
6
