Thermaltronics AF-KIT, User Manual

4

www.thermaltronics.com   support email: support@thermaltronics.com

WIRE ADJUSTMENT ASSEMBLY

Wire Adjustment Assembly

(3a) Guide Nozzle - Solder wire is guided from the (4) Solder Spool Holder into the (3) Wire Adjustment Assembly 
through the Guide Nozzle.
(3b) Tension Adjustment Gear - Along with the (3h) Driver Gear, the two gears push solder wire through the (3) Wire 
Adjustment Assembly into the (5) Guide Pipe Assembly.
(3c) Tension Adjustment Knob - Adjusts the tension of the (3b) Tension Adjustment Gear. Note: Tension should be 
set lower for small diameter solder wires and higher for larger diameter solder wires.
(3d) Release Lever - Push back the release lever to release the (3b) Tension Adjustment Gear when switching 
solder wire.
(3e) Solder Tube Nozzle - Along with the (3g) Locking Screw are used to lock the (3f) Solder Tube in place.
(3f) Solder Tube - A conduit to allow solder wire to pass from the (3) Wire Adjustment Assembly to the Guide Pipe.
(3g) Locking Screw - Used to secure the (3f) Solder Tube in place inside the (3e) Solder Tube Nozzle.
(3h) Driver Gear - Along with the (3b) Tension Adjustment Gear, the two gears push solder wire through the (3) Wire 
Adjustment Assembly into (5) Guide Pipe Assembly.

(3c) Tension Adjustment Knob

(3d) Release Lever

(3g) Locking Screw

(3b) Tension Adjustment Gear

(3h) Driver Gear

(3a) Guide Nozzle

(3f) Solder Tube

(3e) Solder 

Tube Nozzle

GUIDE PIPE ASSEMBLY

(4a) Locking Nut

(4b) Adjustment Nuts

(4c) Guide Clip

Guide Pipe Assembly

(4a) Locking Nut - Fasten securely to lock the (4d) Guide 
Pipe. Loosen to adjust the (4d) Guide Pipe length.
(4b) Adjustment Nuts - Used to adjust the (4d) Guide 
Pipe forward and backwards. Tighten to secure in place.
(4c) Guide Clip - Used to secure the Guide Pipe 
Assembly to the Soldering Hand Piece.
(4d) Guide Pipe - Feeds solder wire to the soldering tip. 
(4e) Nozzle - Change the nozzle when using different 
solder wire diameters.

(4d) Guide Pipe

(4e) Nozzle