Thermann Owner’s Manual
4 Star Gas Hot Water Heater
6
H4127 Rev. B
Plumbing Connections
Hot Water Connection
the hot water pipe should be
connected to either of the RP¾/20
sockets marked "outlet" at the
top of the unit. Please check local
regulations regarding the use of hot
water supply pipework that is not
made of copper.
Insulation of Pipes
For the most economical operation of
the water heater, it is recommended
that all hot water lines are insulated.
Where the hot water pipes are
installed outdoors, the insulation
should be uV stabilised.
Note:
a combined isolating valve/non-return valve/line strainer may be used.
expansion Control Valve only required where local regulations demand although it
is recommended in areas where the water saturation index is above 0.40
(see page 12).
Union
Connection
Non-return
Valve
Line
Strainer
Cold Water
Inlet
Drain
Expansion
Control Valve
Isolating Valve
(Spindle Vertical)
Inlet Connections
Temperature Protection
Water heaters can produce very hot
water. to reduce the risk of scald
injury, it is mandatory under the
requirements of australian standard
as/nZs3500.4 that a suitably
approved temperature control device
be fitted to the hot water supply to
outlets used primarily for personal
hygiene. this valve should be checked
at regular intervals to ensure its
operation and settings remain correct.
