12
INSTALLATION INSTRUCTIONS
1.
2.
3.
26
_0
3_0
1_
13
87
f
f
Keep the water heater slightly tilted.
f
f
Wind out the free leveling foot, but not by more than 30 mm (1.1”).
f
f
Turn the locking nut on the thread of the leveling foot towards the bottom cover. When the locking nut is tight
against the bottom cover, it stabilizes the leveling foot.
26
_0
3_0
1_
13
84
f
f
Push two polystyrene® installation aids with the step-shaped corner underneath the water heater. The water
heater is subsequently set and tilted onto this profile. Ensure that you do not set the water heater down in the
area of the joint edge of the sheet steel jacket, but at least 150 mm (6”) along.
Summary of Contents for TIHP 300
