Product Structure
Installation Guideline
The installation must be in compliance with the National Electrical
Guidelines, as well as your local electrical and plumbing regulations.
1. Make sure the appliance is intact, and the fittings are complete.
2. Please make sure the mains power supply, incoming water pressure and the
grounding conditions are adequate, and the ammeter and wire are at the correct
standard required for installation.
3. The appliance must be properly grounded due to the dedicated branch circuits of
high voltage within the unit. Ground wires must be brought to the 'ground' at the
circuit breaker panel.
4. This appliance
MUST
be permanently connected to the fixed circuit breaker. If you
don’t use the heater, please switch off the circuit breaker.
5. Do
NOT
install this appliance on timber or in the presence of a strong magnetic
field. The appliance can be installed above or under the sink, and must only be
mounted in a
VERTICAL
position near by the water fittings.
Excellence in Hot Water Technology.
6
Terminal Blocks
Bottom Case
N
L
E
Control Board
Display Screen
Flow Meter
Temp.
Sensor
Heating
Chamber
220mm
330mm
2890/ElectricPackagingManuals/A5.indd 6
08/10/2018 10:56
